sailing

Velocir’s Haul Out Update

Long time no post.  As you know, we’re currently in sunny California.  But, that doesn’t mean Velocir is completely out of the picture.  She needs some love and care back on the East Coast, so we have hauled her out of the water for the winter.  It will give us an opportunity to check-up on her and give her the attention that she needs.

The haul-out was very exciting.  As you can see, she slipped out of the cradle, yikes!  This happened for a few reasons.  Mostly, it’s pretty clear in the photo that the strap almost looks amidships, so we all thought we were good to go, but the rudder is just so far forward on her full keel.  After a moment of terror, we eased back into the process.  She is a strong little boat!

Grant did a thorough survey and assessed the projects.  He cleaned her from top to bottom.  Even though we have taken great measures including painting and solar vents installation (which is super combative to mold) Velocir still tries very hard to become musty.  Without these preventative measures she could have built a nice mold colony, but after many months she is just a bit musty and so we wiped down surfaces, no big deal!

On the bottom, Grant started sanding (yes, he used a mask just not in this photo).  The bottom paint did an amazing job protecting her hull.  This is the same paint from before the trip!  Velocir will get a new bottom job in the spring.  For right now, Grant went to work prepping her.  It took extra time because instead of just quickly roughing it up, the paint was sanding off in clumps and peeling instead of just being easy to rough up.  Eventually it came out after some finesse.

To finish up projects, Grant also repaired our ignition switch.  Since we left the Bahamas it has been freezing up. All of the salt and dirt made it grimy, so Grant took it apart and cleaned it thoroughly.  Luckily a quick fix!  For such a specialized part that is specific to the Vega we didn’t want to need a replacement.    The wiring back together probably took the longer than fixing– the wires we used are green, light green and bright green, makes for a fun combination!

Let’s see, what else?  The battery was dead so we fixed a loose connection on the solar panel charge controller.  We took off the running rigging  and ran cheap line through everything to reduce sun and moisture damage to the good stuff.  She will rest well this winter!

We are still adapting to our transition from cruising.  Many stresses and responsibilities, just the fixation with time and schedules can be a hard adjustment.  I mean, we’ve lived in the modern age, but for some reason after the freedoms and confidences cruising affords, being thrust back into the mix is mildly traumatic.  I know, I know, what problems to have.

Thanks so much for following our journey, we will continue to update as we can.

Sail Care, Interview with an Expert – Article in SpinSheet Magazine

Amelia’s article, Sail Care, Interview with an Expert, appears in the April issue of SpinSheet magazine.  Grant worked as a sail inspector for two years at Bacon Sails and Marine Supplies in Annapolis, MD.  Here are some of his tips on Sail Care!!

Click here to read the entire April 2014 issue of SpinSheet magazine!

And, read our blog post on designing Albin Vega Velocir‘s Sail Design.

Interested in what we’ve been up to?  Stay tuned next week for an exciting update, it’ll be something a little different…

Co-Captaining,Can It Be Done? – Article in SpinSheet Magazine!

Amelia’s article, Co-Captaining – Can It Be Done?, appears in the April issue of SpinSheet magazine.  We co-captain Velocir, which is probably not typical of most boating couples.  Happy to say it worked very well for us during our entire voyage– below is the article giving more insight.

Click here to read the entire April 2013 issue of SpinSheet magazine!

Grant’s Sail Care Advice in SpinSheet Magazine!

We are excited to share that Grant has been featured in SpinSheet’s March 2013 issue, sharing his knowledge of sails and how to care for them. Having inspected thousands of sails as an inspector for Bacon Sails and Marine Supplies in Annapolis, MD, he has always wanted to give a few pointers, hoping it would help others to extend the life of their sails.

Check out our past blog post where Grant talks about the sails he designed for Velocir.

Click here to read the entire March 2013 issue of SpinSheet!

For a clearer view, please click on the article below, thanks!

I’m On A Boat- Solar Vent Installation

Before leaving on our trip to the Bahamas in 2011, we installed new solar vents on Velocir.  We had seen many older solar vents in boat yards still going strong after many years and much neglect.

The original installation required us to enlarge pre-existing 3 inch vents holes to 4 inches.  We epoxied the cored deck so that it would be water tight, and installed the vent.  It was great except that in heavy weather (crashing waves and spray) it would leak a bit., otherwise we love them!  This summer our starboard vent stopped working, so we replaced it:

After taking the old vent out we waited a few weeks for a new one (free under warranty) to come in the mail.  Then, Amelia installed it by lightly chiseling off the old foam ring and Dolfinite sealing compound.  Mineral Spirits and kerosene also work really well at getting Dolfinite off.

There are three main pieces to install.  The base (top right), the white ring is the interior trim piece, the foam ring is part of the waterproof bedding on deck, and then the cover piece with the solar panel and motor.  Since we already had holes drilled it was super easy to install.  (Note: Before drilling holes, make sure your vents have solar panels aesthetically going the way you like.)

We put fresh bedding compound, Dolfinite, down before installing the base.  Contrary to what you might assume, Amelia doesn’t just use Dolfinite because there is a cute dolphin on the label.  The other advantages are that with age, the bedding compound is still easy to remove and reapply.  It doesn’t easily dry out under basic storage methods.  (It is messy to apply though, comically so, like peanut butter).

The base fit right in.  The white part of the base slides up and down, allowing air in/out or cutting it off.  There is also a handy bug screen.

And, Viola!  A beautiful new and working solar vent.  Aren’t warranties great?

P.S.  They are very quiet.  Every once in a while one will start to make a ticking sound, so we restart and silence again : )

I’m On A Boat–Downsizing Your Sailboat

Before Motu Iti, Amelia’s parents had cruised and sailed two other bigger 40 foot sailboats.  One cruise was to the Bahamas for a year with a young family, the others summer cruises as a couple and with a young family.

They chose Motu Iti because her smaller size makes her easier to handle and take care of.  Here is a video discussing the best aspects of downsizing to a smaller sailboat!!  And, see Motu Iti’s blog on the topic here.

I’m On A Boat–Using a Nature’s Head

The Nature’s Head Composting Toilet has been a great solution to rid ourselves of stinky holding tanks, repairing valves and finding pump-outs.  Even better, being ecologically friendly on the boat has become effortless for us.

In Georgetown, Bahamas, the pump-out boat went through Elizabeth Harbor every morning, $5 for a pump out.  We thought, I hope he doesn’t notice we don’t need one, because we have the Nature’s Head.  The pump-out guy would get angry on the VHF radio when he wasn’t getting a lot of business, saying outrageous things like “you cruiser’s must like to swim in your own discharge” and various such proclamations.  We thought, how rude, I hope he realizes people have composting heads  now and are considerate to others.

Then, we were blown away when we met two other cruising boats openly proud of their complete disregard for proper discharge, in a crowded cruiser’s harbor too!  Like it was an inside joke they were letting us in on and they were such rebels.

But really it was disgusting and inconsiderate, and there is no excuse, none, especially with a Nature’s Head.  Part of the reason we love to cruise is to be outside and enjoy nature, so even if it’s just something small like our discharge,  we take pride in doing what we can to protect the sea!

Here’s a video from Motu Iti about using a Nature’s Head:

I’m On A Boat–Creating a Cozy Boat Home

It can take a lot of creativity and hard work to make the interior space of a boat warm and inviting.  Aboard Motu Iti, Nancy shows what she did to make the boat feel like home:

Happy Thanksgiving 2012!

It is hard to imagine that it was an entire year ago that we spent Thanksgiving aboard Velocir in St. Mary’s, GA:  https://velocir.com/2011/11/24/happy-thanksgiving/

How time flies!  We are thankful for family and friends this holiday season.  Grant is thankful for our good health, Amelia is thankful for a life full of joy and Crew is thankful for treats……anything for treats.

Last month Velocir made it through hurricane Sandy’s strong winds unscathed. To prepare, we secured many lines to different connection points on Velocir and the dock. She was protected in her cove from the wind, so we just kept ready in case something happened but it was very mild. Our biggest fear was a tree falling, but luckily they held tight!

This week we winterized Velocir in anticipation of the long cold winter months ahead.  We used environmentally safe anti-freeze and emptied the water tanks.  There was a little fish in our water filter, so we set him free.

We even got out for a weekend sail with friends in mid-November, yay warm weather!  The fall colors are a beautiful time to explore the tree-lined creeks of the Chesapeake Bay.

So much to be thankful for.  Happy Thanksgiving!

Bon Voyage to MOTU ITI!

We are excited to share with everyone that MOTU ITI has officially left on their cruise this winter.  After a lot of work and planning, their cruising dreams have become a reality.  They were the boat we featured in our “I’m On A Boat” Youtube series.

Their small sailboat is a Camper Nicholson 31.  Check out their blog at www.sailmotuiti.com!